$39.00 – $60.00
These cables for the Nucleus-M give you run/stop capabilities in camera systems that support it. Simply plug the 7-pin end of the cable into one of the motors and the other end into the R/S port of the camera.
Note that this cable was specifically designed for the Nucleus-M so the R/S function only works with the Nucleus-M’s own hand unit and hand grips.
Weight: 0.09lbs
Length: 68.6cm
Color: Black
Materials: Copper, rubber, aluminum-alloy
I've bought this cable to use with my DSMC1 Red Epic MX to use in control port (The cable is RED DSMC2). I have connected the cable to the motor, also the motor is powered via D-Tap. No matter what setting i choose in camera -the cable doesn't work. My camera settings are: Redlink command protocol - tried enabled and disabled BRAIN GPIO HIGH: Start Record BRAIN GPIO LOW: Stop Record GPIO - have tried Sync Out and Record out What am I doing wrong? AC's told me this cable is the better one to use with DSMC1 cams. Is the cable faulty? I've tried to reboot the handles etc. - nothing works
AUWorks flawlessly with the Ursa Mini Pro G2
USIt works great on my C500. It would be nice if the TRS plug side was straight and not an elbow but not a huge factor.
Works great to activate run/stop - still need the p-tap power cable plugged into the motor.
USI walked in September 10, 2024 and Rickardo took great care of me. Not only did I get a meaningful conversation about the gear I had questions about. But we also discussed movies and some time past realizing I was just enjoying my experience inside the store.
